How to use the rolling machine? What problems should be paid

The plate bending machine is a device that uses work rolls to bend the sheet. It can form parts of different shapes such as cylindrical parts and tapered parts. It is a very important processing equipment. It can move the work roll through external forces such as hydraulic pressure and mechanical force, and bend the plate into elliptical parts, arc-shaped parts, cylindrical parts and other parts. So how do you use the plate bending machine? What problems should be paid attention to in use? Take a look!
 

 

 

1. Clean the pinion gear, pinion gear bearing and bearing seat. After cleaning, add oil to the bearing, buckle the cover and tighten the screws. Check whether the housing of the reducer and auxiliary reducer is clean. If cleaning is required, apply oil after cleaning. Measure and check the length of the coupling, and check whether the coupling on the output shaft of the reducer and the pinion shaft is installed in place.
 

2. Clean the foundation and foundation holes, and make the reducer, motor and auxiliary drive mortar pier according to the height given in the drawing.

 

3. To pre-bend the board, first adjust the board that needs to be pre-bent to a suitable position (determined by the position where the board needs to be pre-bent). Secondly, when adjusting the bracket movement cylinder, move the two brackets to an appropriate trust position so that the pre-bent chess meets the opponent's material. Finally, operate the upper roller and the lower pressure cylinder to the surface of the material (parallel to the left and right).

 

4. Start the main motor, press down the button to start rolling, and make the motor pressurize or rotate forward several times to complete the rolling.
 

 

 

    1. The automatic plate rolling machine must be managed by a dedicated person.

 

    2. The operator must be familiar with the method of use, and can only operate after the approval of the management.

 

    3. Before starting, carefully check whether the safety device is in good condition. During operation, it is strictly forbidden to put hands and feet on the rollers, transmission parts and workpieces.

 

    4. Multi-person collaborative work requires special command, and overload operation of the automatic plate rolling machine is strictly prohibited. The tilting reset of the upper roll lifting and turning bearing and the balance of the upper roll must be carried out after the main drive stops. It is forbidden to accumulate workpieces and garbage in the workplace, and always keep the automatic plate rolling machine tool and the place clean.

 

    5. After the operation is over, the power supply should be cut off and the power supply box should be locked.
 

 

    The above is the related content of "How to use the plate rolling machine?" and "What problems should be paid attention to when using the plate rolling machine?" The relevant content is for your reference.